Generatoriai
vScan TX - 1W output power signal transmitter
The indicated price is valid ordering till 06.09.2025.
The stock is informative
vScanTx - 1W output power signals transmitter.
The vScanTx is one-watt output power transmitter and has one induction frequency - 33 kHz and two direct connect frequencies - 33kHz and 131kHz. The LED indicators on the transmitter show the frequency selected, output level and battery status. An audio indicator beeps to advise the quality of the connection.
This one-watt transmitter can transmit the locate signal onto the target line three ways. By direct connection, if direct access to the line is available, by induction by simply putting the transmitter in induction mode and placing it over the target line with the induction arrow in line with it or by clamp mode and using the induction clamp to clamp around the target line.
The wide frequency range from the vScanTx transmitter makes this a very versatile transmitter. The 33kHz induction frequency makes it ideal for inducing the signal onto large diameter, direct buried iron pipes with bell and gasket connections, and for using the induction clamp around smaller pipes. The lower 33kHz are good for direct connection to trace cables, and the 131kHz direct connection is good for high resistance pipes.
Specifications:
1 watt – in High output level
0.1 watt – in Low output level
Maximum Output Voltage 60V RMS
Maximum Output Current Maximum output current = 70mA RMS constant current
Output Protection Output protected against accidental connection to up to 240V AC
Audio Indication:
- Beep constantly – for high voltage detected
Weight:
-With Rechargeable battery tray: 0.92 kg
Dimensions: 460mm x 90mm x 65mm
Display Flashing red LED lights show active transmit and output modes
Power Options:
- 4 x Alkaline “D” cells
- Optional Li-Ion rechargeable battery pack
Battery Life At 1 watt, i.e., full output setting.
- Alkaline – typically 12 hours
- Li-ion – typically 36 hours
(Based on the maximum output into 300-ohm load and 50% duty cycle.)
Environmental IP54 and NEMA 4
External Connectors 1 x 3 pin XLR socket for direct connection wires and clamps
Temperature Range:
- Operating: -20ºC to 50ºC
- Storage: -40ºC to 60ºC
The transmitter comes standard with direct connection cables, grounding stake, clip-on carrying/scanning strap, "D" size alkaline battery pack, USB data cable and LV/ENG instructions.
